Pulsar Helion 2 XP50 Thermal Monocular Discontinued
The Pulsar Helion 2 XP50 Thermal Monocular has been discontinued. For alternatives, please click here.
The Helion 2 XP50 has a generation 2 thermal sensor, providing even more detail in difficult environmental conditions such as cold mornings, rain or fog.
New <40mK Thermal Sensor
By now, most thermal users are familiar with the sensor resolution of a device e.g. 640×480, and also the pixel pitch e.g. 17µm. The improvement of these new Series 2 devices concentrates on a key specification of thermal sensor technology – the NETD value.
The NETD (Noise Equivalent of Temperature Differential), expressed in millikelvins (mK) is one of the most important parameters for thermal sensors as it describes their sensitivity. The lower the NETD value, the higher the sensitivity.
In existing Helion, Trail and Accolade series models the NETD value was sub 60mK. The new <40mK sensor, exclusively manufactured by ULIS for Pulsar puts Pulsar devices at the forefront of the market with the devices all featuring a better image in conditions where there is a low-temperature difference such as during rainfall, fog or cold mornings. These environmental conditions are the most difficult for thermal imagers and this new sensor will provide a clearer image for users.
The Helion 2 XP50 series features a 640×480 17µm thermal sensor and a F50/1.2 lens that provides a detection range of up to 1800m for a deer-sized object. The lens is interchangeable and can be replaced with an F38/1.2 lens (PUL-79054 F38 Thermal Len) allowing the device to satisfy the need to have a spotter with a wide field of view (with the 38mm lens fitted) or by switching the lens, a high magnification unit (with a 50mm lens fitted).
In brief the Helion 2 Series Features:
- Long detection range
- High magnification
- Step-Up digital zoom
- Frost-Resistant AMOLED display
- 50Hz Refresh rate
- Focusable lens
- Dioptre control
- 8 Colour modes
- “Display Off” mode
- PiP mode
- Built-In photo & video recorder
- 16GB internal memory
- Stream Vision compatible
- User Friendly controls
- Stadiametric rangefinder
- Wide operating temperature (-25°C to 50°C)
- Four observation modes (Forest, Rocks, Identification and User)
- Three calibration modes (Manual, semi-auto, auto)
- Pixel correction
- Quick-Change, rechargeable IPS5 battery pack
- MicroUSB port
- Retained lens cap
- IPS Battery charger
- Interchangeable lens (XP models)
- Image Boost Technology
|Dimensions||23.4 × 5.5 × 5.8 cm|
|Sensor Resolution||640×480 17µm <40mK|
|Photo & Video Recorder||Built-In|
|Field of View||12.4°|
|Operating Temperature||-25°C to 50°C|
Looking for alternatives to the discontinued Pulsar Helion 2 XP50 Thermal Monocular? Click here.