Pulsar Helion 2 XQ50F Thermal Monocular

£2,299.00

The Helion 2 XQ50F has a generation 2 thermal sensor, providing even more detail in difficult environmental conditions such as cold mornings, rain or fog.

Description

The Helion 2 XQ50F has a generation 2 thermal sensor, providing even more detail in difficult environmental conditions such as cold mornings, rain or fog.

New <40mK Thermal Sensor

By now, most thermal users are familiar with the sensor resolution of a device e.g. 384×288, and also the pixel pitch e.g. 17µm. The improvement of these new Series 2 devices concentrates on a key specification of thermal sensor technology – the NETD value.

The NETD (Noise Equivalent of Temperature Differential), expressed in millikelvins (mK) is one of the most important parameters for thermal sensors as it describes their sensitivity. The lower the NETD value, the higher the sensitivity.

In existing Helion, Trail and Accolade series models the NETD value was sub 60mK. The new <40mK sensor, exclusively manufactured by ULIS for Pulsar puts Pulsar devices at the forefront of the market with the devices all featuring a better image in conditions where there is a low-temperature difference such as during rainfall, fog or cold mornings. These environmental conditions are the most difficult for thermal imagers and this new sensor will provide a clearer image for users.

The Helion 2 XQ series features a 384×288 17µm thermal sensor and a F50/1.0 (XQ50F) or F35/1.0 (XQ38F) lens that provides a detection range of up to 1800m (XQ50F) & 1350m (XQ38F) for a deer-sized object.

In brief the Helion 2 XQ Series Features:

  • Long detection range
  • High magnification
  • Step-Up digital zoom
  • Frost-Resistant AMOLED display
  • 50Hz Refresh rate
  • Focusable lens
  • Dioptre control
  • 8 Colour modes
  • “Display Off” mode
  • PiP mode
  • Built-In photo & video recorder
  • 16GB internal memory
  • Stream Vision compatible
  • User Friendly controls
  • Stadiametric rangefinder
  • IPX7
  • Wide operating temperature (-25°C to 50°C)
  • Four observation modes (Forest, Rocks, Identification and User)
  • Three calibration modes (Manual, semi-auto, auto)
  • Pixel correction
  • Quick-Change, rechargeable IPS5 battery pack
  • MicroUSB port
  • Retained lens cap
  • IPS Battery charger
  • Image Boost Technology

Additional information

Dimensions 22.6 × 5.5 × 5.8 cm
Manufacturer

Pulsar

Magnification

4.5-18.0x

Objective

50mm

Battery

IPS5

Waterproof

IPX7

Photo & Video Recorder

Built-In

Resolution

1024×768 AMOLED

Operating Temperature

-25°C to 50°C

Field of View

7.5°

Detection Range

1800m

Rangefinder

Stadiametric

Sensor Resolution

384×288 17µm <40mK

Internal Memory

16GB

Key Points

  • 4.5-18.0x Magnification
  • Frost-Resistant AMOLED display
  • 8 Colour modes
  • Wide operating temperature (-25°C to 50°C)